Ebsomat

Component Specifications:

more
brochure

EBSOMAT 400 : Axial Trimmer/Former

Manual-Model
This new progressive and universal to use machine is suited for the processing of axial components. Through manual operation it is possible to read a production-speed of circa 10.000 components per hour.

Motor-Drive
For treating even more components the EBSOMAT 400 can be fitted with a motor-drive. Therewith you are able to increase the capacity on 14.000 compon­ents per hour.

more
brochure

• No mechanical stress of components due to interchangeable cutting, bending and forming
• Gradual adjusting of the cutting units realizes an „overbending“ of the wire-components by more than 90° respectly 180°
• The bending components are supplied with a special roller design, so that the components can not be damaged by overbending
• Pitches and length of the connecting wires can be adjusted gradually
• Already the standard tooling allows the processing of the components either in horizontal or vertical mode
• Gradual adjusting of speed