Burst & Zick

C 042: Cutting, Stamping & Forming Device
The C 042 is designed to cut, stamp and bend the leads of axial components. By the use of interchangeable tool sets a variety of form configurations can be achieved with this device. The change can be done easy and secured in less than two minutes. The settings will be displayed on the scale of the device. The embossing for the leads are tooling-specific.
This tools are produced to meet customer requirements. The components are hand fed into the tooling. The component body has to be centered between the bending anvils. After the Foot pedal is depressed, the component leads are clamped on both sides. The leads are then cut to length and depending on the form shape the required lead features are put in the leads at this time. After that, the leads are bend to the 90° configuration. The processed component is then rejected by the front of the device.

C 043 / C 043 E: Cutting, Stamping & Forming Device
The C 043 is designed to cut, stamp and bend axial leaded components for both horizontal and vertical mounting. To make the insertion of components with short leads into PCBs possible, the leads have to be cut to suitable length, bend to the required pitch and -if necessary- stamped.
Both, suitable length and required pitch, can be adjusted by adjusting screws. After this set-up the components can be processed. Option: the adjustments can be checked by a digital display.
The stamping result for the leads depends on the used tool. These tools can be manufactured to meet customer requirements. The machine can be re-set for the different tools.The taped components can be processed automatically. The processing speed is continuously variable. The tool change for different bending dimensions takes about 2 minutes.